This is the punch I used for this one. This is a very small punch! But the flower is so cute!
Punch out 6 flowers, then punch a hole in the center of each piece to allow you to put a brad inside. Shape them by using your petal roller or the end of a large brush! Most of you already know how to do this I am sure. Take the first flower and put the brad down through the top of the flower. Pull the first petal towards the brad then glue the second petal to the first one, continue doing that with the remaining petals, turning it as you go but also keeping it nice and tight as this will be the center of your flower and you won't see the brad. Put on the next flower and place the petals off set from the first one above it put a little dab of your favorite glue to hold it in place and keep doing this until you have used all your punched out flower's. Let the glue dry and it is ready to be used. This is how the finished flower looks......
There you go! Have fun and if you have any other sizes of this punch try that one too! Keep in mind that it works the best with a 5 petal punch. How do I know that? Cause I tried a 6 petalled one. That just ended up being an exercise in frustration!!!! Maybe it was the shape of the petals but it didn't work as nicely as this one did.
Have a great day y'all!!!